PowerGuard® 35kV 133% Shielded Power Cable AL Conductor 420 mils TRXLPE Copper Tape PVC Jacket

• Triple-extruded for clean interfaces
• Dry nitrogen cure for enhanced performance
• Class 10,000 environment utilized for material handling
• Excellent moisture resistance
• High dielectric strength
• Low dielectric loss
• Excellent resistance to treeing
• Clean-stripping insulation shield
• Sunlight and Moisture Resistant
• Approved for CT use 1/0 and Larger

• ANSI/ICEA S-97-682
• UL 1072
• AEIC CS8 as applicable for TRXLPE (Tree-Retardant Cross-linked Polyethylene) insulated shielded power cable.
• ICEA T-31-610
• CSA Standard C68.5-07 File # 257759 Primary Shielded and Concentric Neutral Cable for Distribution

• Normal ..............105 ºC
• Emergency*........140 ºC
• Short Circuit........250 ºC

• Copper conductors
• CPE (chlorinated polyethylene) Jacket conforming to the requirements specified for chlorinated polyethylene jackets in ICEA. The average thickness shall be in accordance with Table 4-3 of ICEA and the minimum spot thickness shall be not less than 80% of the average thickness
• Non-filled conductor
• Compact Strand Conductor

1. Extruded layer thicknesses and insulation and insulation shield diameters are in accordance with ANSI/ICEA S-97-682 for shielded power cables rated 5-46 kV and also meet the requirements of the latest revisions of AEIC CS8.
2. Ampacity based on earth thermal resistivity of 90ºC-cm/watt, 105ºC conductor temp., 20ºC earth ambient temperature, 75% load factor and 36" depth of burial. Values are based on one three-phase circuit, one conductor per phase, in flat adjacent configuration (direct buried) with metallic shield bonded at each end.

Dimensions and weights not designated minimum or maximum are nominal values and subject to manufacturing tolerances. In this context, weight means mass.